I'm thinking of getting a mg zs 1.8 but here they have bad head gasket problem does anyone have any views ? - mg head
Tony saved many Hasle, skip the MG ZS!
The problem with them is simple, the engine is made of aluminum, both the head and engine block.
Screws in the head, block, then the main bearing strata. Thus, if a failure to replace the seals on a large task, the Board of Directors. Expect to pay about 600 pounds to do the job properly.
It is a shame because the engine seires K is a lot more energy than the engine size.
Yes.
Saturday, January 2, 2010
Mg Head I'm Thinking Of Getting A Mg Zs 1.8 But Here They Have Bad Head Gasket Problem Does Anyone Have Any Views ?
Subscribe to:
Post Comments (Atom)
1 comments:
Lead with honesty, not just the ideas clear, but the Council not only k18 engine cylinder head gasket, but melts a piston normally (approximately EUR 1700 by a new engine + install and not much opportunity to motors, it is cheaper). The banks are in bad taste and disintegrated door card lock rattle sticks boot to boot not include the list goes on and on. was in many areas are not bad on the hand and work on them is relatively easy.Hope this helps!
Post a Comment